First thing I would do here is make sure your systems firmware is upto date. Follow this Apple T/N:. You might have something still newer depending on your OS version. • Hint: the last digits (after the last dot) are hexadecimal so you'll need to convert it to decimal to know if your systems version is newer or older than the T/N. Mavericks and newer OS's have firmware updaters within the OS installer. You'll need to get a SATA to USB adapter so you can connect your SSD externally to your system. Here's one unit: for 2.5' drives. 1) After the new SSD has been installed into the computer, boot to internet recovery by pressing Command-Option-R until a globe is seen. If the computer is not connected to the internet via an ethernet connection it will prompt for a wifi network to be chosen. With the SSD plugged in to your system you'll need to run Disk Utility to partition the drive with GUID and format it with Mac OS Extended (Journaled) partition. The next step is to download from the Apps Store the OS installer. Run the installer selecting the SSD drive it will install a fresh OS onto your SSD. Once done you'll want to double check if it's working correctly. Restart the system and press the Option key so you can select the SSD as the boot up drive. If the system starts up you can then shut down the system and swap over the drives. Follow this IFIXIT guide:. Yes, the OS installer is placed in your Application folder. You'll want to copy it to your desktop or another folder as the installer in the Application folder will self erase after you run it from there. This gets a bit confusing here as it depends on what you want to do. First make a full backup of your stuff (TimeMachine) On another drive. If you are swapping out your current drive and want to save your stuff you'll want to have both drives connected to your system. Then run the Installer to first formatting your new SSD and then install the OS (hint: use a new user account name). At the end it will ask you if you want to migrate your user accounts, Apps and data over. If you want to limit what is transferred either clean things up before hand or limit your folders as you want to move over. I would strongly recommend you also replace the HD cable and place some tape under the cable that rubs against the upper case. Don't make the mistake by insering the new ssd stright out of the box. OS and disc formatting need to be done first. I wanted to install a new OS into a mac mini and had no previous useable HD. The way I successfully did it was: Connect ssd via sata cable to a Mac. (Ssd icon shows on desktop) Disc Utilty/ Erase ssd then partition ssd and give it a name. Inset flash drive with bootable OS ( icon appears on desktop) Click on OS icon. Disc Utility/ Install OS then select Show all disks Click on new SSD and install. When cooked, remove ssd from Mac and insert into mac mini. Then boot up. ![]() Customers often ask us why their new blank hard disk drive (HDD) or solid state disk (SSD) doesn’t show up on their computer, ready to blame their Plugable docking station. Microsoft access for mac trial version. Most often the drive just needs to be initialized, partitioned, and formatted. In this post we present a step-by-step guide for doing this. Initializing prepares the drive to be used by the computer, partitioning sets aside specific areas of the disk for data, and formatting sets up the framework the computer uses to store that data. We’ll cover the most common scenarios we run into, starting with Windows and finishing with Mac OS X instructions. ![]() The following steps apply to our,,, and our entire lineup. They also apply to new hard disks that are installed inside your computer and potentially other docking stations/enclosures/adapters. We’ll be using a 4TB hard drive as our example. Before we get started, a brief word of caution is essential. Initializing and formatting a hard drive will erase *all* information on that drive.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |